mattp
Full Member
Posts: 37
|
Post by mattp on Feb 3, 2021 2:03:03 GMT -8
I've started using the Textmode firmware to connect to a 68k design I'm using. It works fine until it reaches the bottom of the screen. The scrolling seems to just clear the screen and after that no characters are displayed. I can reset it by sending the ANSI codes for screen mode.
Is this the code which looks after scrolling?
: down1 1 cy +! cy @ t.H 1- = if yo @ 1+ hmod yo ! -1 cy +! 0 t.W lineclr cmd_memcpy $3020d8. >gd yo @ 4 * t.scr + w>gd 4 w>gd then ; I'll post this in github as well.
|
|