david
New Member
Posts: 4
|
Post by david on Mar 1, 2014 7:54:57 GMT -8
Hi there,
i have a connectEVE board from MikroElektronika. This is a FT800 breakout board.
So i want to use the GD lib to run the connectEVE from a arduino uno. because there is no arduino Lib for this board.
The gameduino uses the FT800 from FTDI to. So i try to run the "Hello World" example. But it dosent work.
Have you any idea why.
Its the same Display and the same chip. whats wrong?
greetings. david
|
|
david
New Member
Posts: 4
|
Post by david on Mar 1, 2014 8:03:05 GMT -8
so. i find a solution: the Gameduino2 Lib use the Pin 8 for CS the GPU on the Arduino. The example programs from FTDI uses Pin 10 to CS the GPU. just change the CS Pin and i works. thank you for the good library for the connectEVE FT800 breakoutboard.
|
|
david
New Member
Posts: 4
|
Post by david on Mar 1, 2014 9:03:21 GMT -8
And if you use the Gameduino2 library for the connectEVE FT800 breakout board. you must set the value in the GD2.ccp file (Line 6): #define PROTO 1 -> #define PROTO 0 Now it works fine -> with the right Rotation und Colorshematic i hope it helps have a nice day!
|
|
|
Post by huszi on Jul 2, 2014 11:02:39 GMT -8
thx for your post !! it was helpfull
|
|
|
Post by Roi Yozevitch on Apr 13, 2016 10:44:57 GMT -8
Hello Guys How do I change pin 8 to pin 10?
I want to work with connecteve and gameduino 2 using teensy 3.1 board
|
|
|
Post by Roi Yozevitch on Apr 14, 2016 23:24:01 GMT -8
I found the answer! there is a wiring.h file which you need to change.
|
|