peterm
Junior Member
Posts: 17 
|
Post by peterm on Feb 23, 2014 14:16:22 GMT -8
James
Do you sell the Gameduino LCD seperate or would I have to buy Gameduino2 again ?
(sent an email but may have been missed, I damaged my LCD).
|
|
|
|
Post by jamesbowman on Feb 23, 2014 15:52:30 GMT -8
|
|
|
|
Post by madivad on Mar 7, 2014 13:34:41 GMT -8
Did you damage the display or just the touch screen? I managed to damage mine  and whilst it worked ok for a little while, the touches just kept getting worse and worse until finally they were unresponsive. I found this on ebay. I bought it and have successfully ripped off the old one and put this one in its place. www.ebay.com.au/itm/181256946458The only problem is you have to force a recalibration to eeprom EEPROM.Write(0,0) in a sketch and then rerun it |
|
peterm
Junior Member
Posts: 17
|
Post by peterm on Mar 8, 2014 19:02:49 GMT -8
madivad
No the LCD is cracked and damaged,
I was spraying some PCB cleaner on to the Gameduino2 header pins (I had some bad connection at times)
but some of the solvent leaked inside the LCD which showed some patches on the screen.
I pulled the LCD apart and found plastic reflector was etched(eaten away) by the solvent, as I assembled
it back together I some how forced it a bit too much and cracked the glass part of the LCD.
|
|
peterm
Junior Member
Posts: 17
|
Post by peterm on Mar 30, 2014 2:42:27 GMT -8
For what its worth I am going to order another Gameduino2 from James.
|
|
and whilst it worked ok for a little while, the touches just kept getting worse and worse until finally they were unresponsive.