Post by selcuk06 on Nov 25, 2017 0:01:38 GMT -8
Yes, sure,
As mentioned in the forums I used; you should install SdFat library first. From the github site below.
github.com/greiman/SdFat
Then, get the GD3 SDIO library from the link below and install.
github.com/RndMnkIII/GD3_SDIO
It worked with my teensy 3.6 + riverdi breakout board 20 + riverdi FT813 7 inch capacitive touch display combo. I am using a FAT32 formatted 4GB sandisk microsd memory card inserted directly to teensy 3.6 board.
I have arduino 1.8.5 IDE with teensyduino 1.4 installed. Hope it works in your system too
As mentioned in the forums I used; you should install SdFat library first. From the github site below.
github.com/greiman/SdFat
Then, get the GD3 SDIO library from the link below and install.
github.com/RndMnkIII/GD3_SDIO
It worked with my teensy 3.6 + riverdi breakout board 20 + riverdi FT813 7 inch capacitive touch display combo. I am using a FAT32 formatted 4GB sandisk microsd memory card inserted directly to teensy 3.6 board.
I have arduino 1.8.5 IDE with teensyduino 1.4 installed. Hope it works in your system too
