BrewBot
Junior Member

busy
Posts: 21
|
Post by BrewBot on Feb 18, 2016 20:55:48 GMT -8
After a half year of taping the display to a cardboard box, I decided to 3d print a bezel to mount the gameduino in. To mount the screen and bezel I laser cut a box from acrylic for securing the project check it out at www.thingiverse.com/thing:1350072I am using an arduino Mega 2560, so the screen is run with a few short jumpers. after laser cutting the box I added a few zip tie holes and a cutout for the usb plug in (if doing it again, i'd just laser cut these holes to make it easier). Overall turned out quite nice    ![]()
|
|
BrewBot
Junior Member

busy
Posts: 21
|
Post by BrewBot on Feb 18, 2016 22:40:49 GMT -8
|
|